HIGHER ORDER MULTIFUNCTION FILTER USING CURRENT DIFFERENCING BUFFERED AMPLIFIER (CDBA)

Authors

  • SHEKHAR-SUMAN BORAH Dept. of Electronics and Communication Engineering, Indian Institute of Information Technology Guwahati, Guwahati-781015 Author
  • MOURINA GOSH Dept. of Electronics and Communication Engineering, Indian Institute of Information Technology Guwahati, Guwahati-781015 Author
  • ASHISH RANJAN Dept. of Electronics and Communication Engineering, National Institute of Technology Manipur, Imphal-795001 Author

Keywords:

Current differencing buffered amplifier (CDBA), Current feedback operational amplifier (CFOA), Active multifunction filter

Abstract

This research article comes with a higher-order multifunction filter design, specifically low pass (LP), high pass (HP), and bandpass (BP) filter using a current differencing buffered amplifier (CDBA) as an active element. A general voltage transfer function can be observed in four admittance terms to facilitate the fifth-order filter function. The investigation of the proposed design is verified using PSPICE simulation using a CMOS-based CDBA structure as an active block and integrated with 0.5 µm CMOS technology parameter. To explore the effect of variations due to specific components on the proposed filters' performance has been examined along with the sensitivity, non-ideality analysis, and Monte-Carlo simulation. The simulation results are found in close agreement with the theoretical results. The proposed circuit achieved low power consumption and a low percentage of total harmonic distortion (%THD) which is suitable for low power VLSI design. The commercially available current-feedback operational amplifiers (CFOA based IC AD844AN are also used for experimental verification.

References

(1) C. Toumazou, F.J. Lidgey, D. G. Haigh, Analogue IC design: the current-mode approach, Peter Peregrinus Ltd, pp. 11-124. 1990.

(2) Y. Li, Y. Xi, Z. Fan, Y. Zhang, J. Wu, Systematic synthesis of second generation current controlled conveyor based two thomas filters with orthogonal Tune of pole frequency and quality factor, Rev. Roum. Sci. Techn.– Électrotechn. et Énerg., 62, 1, pp. 76-81, 2017.

(3) B. Wilson, Recent developments in current conveyors and current mode circuits, IEEE Proceedings G Circuits, Devices and Systems, 137, 2, pp. 63-77, 1990.

(4) A. Jantakun, Voltage differencing transconductance amplifier based mixed- mode quadrature oscillator, Rev. Roum. Sci. Techn.– Électrotechn. et Énerg., 61, 1, pp. 68-72, 2016.

(5) S. Minaei and E. Yuce, All grounded passive elements voltage mode DVCC based universal filters, Circuits, Systems, and Signal processing, 29, 2, pp. 295-309, 2010.

(6) J. Jin, C. Wang, Current-Mode four-phase quadrature oscillator using current differencing transconductance amplifier based first-order allpass filter, Rev. Roum. Sci. Techn.– Électrotechn. et Énerg., 57, 3, pp. 291-300, 2012.

(7) R. Singh, D. Prasad, Novel current-mode universal filter using single FTFNTA, Indian Journal of Pure & Applied Physics, 58, 8, pp. 599-604, 2020.

(8) M. Ghosh, S. K. paul, design of lossless grounded negative inductance simulator using single operational transresistance amplifier, Rev. Roum. Sci. Techn.– Électrotechn. et Énerg., 59, 4, pp. 381-390, 2014.

(9) S. S. Borah, A. Singh, M. Ghosh, A. Ranjan, Electronically tunable higher-order quadrature oscillator employing CDBA, Microelectronics Journal,108, 104985, pp. 1-18, 2021.

(10) W. Tangsrirst, T. Pukkalanun, W. Surakampontorn, CDBA-based universal biquad filter and quadrature oscillator, Active and Passive Electronic Components, 2008, pp. 1-6, 2007.

(11) S. A. Bashir, N. A. Shah, Voltage mode universal filter using current differencing buffered amplifier as an active device, Circuits and Systems, 3, 3, pp. 278-281, 2012.

(12) M. Koksal, M. Sagbas, Second order band-pass filter design using single CC-CDBA, Circuits, Systems & Signal Processing, 27, 4, pp. 461–474, 2008.

(13) S. Ozcan, A. Toker, C. Acar, H. Kuntman, O. Cicekoglu, Single resistance-controlled sinusoidal oscillators employing current differencing buffered amplifier, Microelectronics Journal, 31, 3, pp. 169-174, 2000.

(14) S. Pisitchalermpong, T. Pukkalanun, W. Tangsrirat, W. Surakampontom, Current differencing buffered amplifier based multiple-output biquadratic filters, IEEE Conference on Electron. Devices and Solid-State Circuits, pp. 521-524, 2005.

(15) C. Acar, H. Sedef, Realization of n-th order current transfer function using current differencing buffered amplifiers, International Journal of Electronics, 90, pp. 277-283, 2003.

(16) S. Ozcan, H.Kuntman, O.Çiçekoglu, Cascadable Current Mode Multipurpose Filters Employing Current Differencing Buffered Amplifier (CDBA), International Journal of Electronics and Communication, 56, 2, pp. 67−72 (2002).

(17) C. Acar, H. Sedef, Realization of nth-order current transfer function using current-differencing buffered amplifiers, International Journal of Electronics, 90, 4, pp. 277–283, 2003.

(18) K. N. Salama, A. M. Soliman, CMOS operational transresistance amplifier for analog signal processing, Microelectronics Journal, 30, 3, pp. 235–245, 1999.

(19) W. Tangsrirat, W. Surakampontorn, Realization of multiple-output biquadratic filters using current differencing buffered amplifier, International Journal of Electronics, 92, 6, pp. 313-325, 2005.

(20) V. Sawangarom, T. Dumawipata, W. Tangsrirat, W. Surakampontorn, Cascadable three-input single-output current-mode universal filter using CDBAs, The ECTI International Conference, pp. 53-56, 2007.

(21) A. U. Keskin, Multifunction biquad using single CDBA, Electrical Engineering, 88, 5, pp. 353-35, 2006.

(22) P. Gupta, R. Pandey, N. Pandey, Voltage mode single CDBA based multifunction filter, IOP Conf. Series: Materials Science and Engineering, 225, pp. 1-9, 2017.

(23) T. K. Paul, R. R. Pal, Floating gate MOSFET based current differencing buffered amplifier and its applications as third-order filters, International Journal of Computational Engineering Research (IJCER), 9, 3, pp. 53-61, 2019.

(24) Y. S. Hwang, Z. H. Huang, J. Jong. Chen, W. T. Lee, High-order current-mode filters based on current differencing buffered amplifiers, International Conference on Communications, Circuits and Systems, Japan, 11-13 Jul., 2007.

(25) Herman Sedef, CevdetAcar, On the realization of voltage-mode filters using CDBA, Journal of RF-Engineering and Telecommunications, 54, 9, pp. 198–202, 2000.

(26) A. U. Keskin, E. Hancioglu, Current mode multifunction filter using two CDBAs, International Journal of Electronics and Communications, 59, 8, pp. 495-498, 2005.

Downloads

Published

12.03.2022

Issue

Section

Électronique et transmission de l’information | Electronics & Information Technology

How to Cite

HIGHER ORDER MULTIFUNCTION FILTER USING CURRENT DIFFERENCING BUFFERED AMPLIFIER (CDBA). (2022). REVUE ROUMAINE DES SCIENCES TECHNIQUES — SÉRIE ÉLECTROTECHNIQUE ET ÉNERGÉTIQUE, 67(1), 59-64. https://journal.iem.pub.ro/rrst-ee/article/view/154