DANDELION OPTIMIZATION-BASED MODIFIED ULTRA SPARSE MATRIX CONVERTER FOR UNBALANCED AND HARMONIC GRID
DOI:
https://doi.org/10.59277/RRST-EE.2024.69.4.7Keywords:
Current space vector modulation method, Dandelion optimization, Doubly fed induction generator, Ultra-sparse matrix converter, Z-source networkAbstract
Variations in wind speed led to a non-constant power output from the wind energy conversion system (WECS). With wind energy penetration into utility grids increasing, there are challenges in the power quality of the electricity supply. Several existing techniques have been introduced; however, they are challenged by harmonics in wind power output from WECS and traditional matrix converters, which are inefficient due to their high switch count, low voltage transfer ratio, and sensitivity to changing conditions. In this research, a modified ultra-sparse matrix converter (MUSMC) has been proposed to improve the quality of wind power and feed the power to the grid. A modified ultra-sparse matrix converter configuration is designed for power transfer from the WECS to the grid. A dandelion closed-loop-based optimization (DLO) method is presented for injecting harmonically less electricity from wind power systems into the grid. The suggested DLO-based MUSMC system is designed to provide a voltage gain ranging from 0.8 to unity. The proposed system's performance is simulated in MATLAB/Simulink R2021a and tested while considering grid harmonics, an unbalanced grid, and changes in modulation schemes. According to the simulation findings, the suggested modular control approach with the MUSMC performs well under all three test situations, and the FFT analysis demonstrates the control strategy's superiority. This proposed methodology decreases the system's losses, size, and cost.
References
(1) D.S. Vanaja, A.A. Stonier, G. Mani, S. Murugesan, Investigation and validation of solar photovoltaic-fed modular multilevel inverter for marine water-pumping applications. Electrical Engineering, pp. 1–16 (2021).
(2) R. Elumalai, Maximum power quality tracking of artificial neural network controller-based double fed induction generator for wind energy conversion system, Rev. Roum. Sci. Techn. – Électrotechn. Et Énerg., 69, 2, pp. 189–194 (2024).
(3) G.R. Bruzinga, A.J. Sguarezi Filho, A. Pelizari, I. Oliani, Comparison of analytical and numerical methods for PMSG design applied to D-type wind generators, IEEE Latin America Transactions, 100 (XXX) (2022).
(4) K. Gireeshma, S. Chandramohan, A Review on LVRT and HVRT requirements and enhancement methods for DFIG wind turbines in INDIA, International Virtual Conference on Power Engineering Computing and Control: Developments in Electric Vehicles and Energy Sector for Sustainable Future (PECCON), May, pp. 1–6 (2022).
(5) R.A. Oliveira, M.H. Bollen, Magnification of transients at the voltage dips starting and its impacts on DFIG-based wind power plants, Electric Power Systems Research, 211, 108244 (2022).
(6) A. Ramalho, M.A. Vitorino, M. Correa, L.A.C. Costa, E. Braga-Filho, New family of two-to-three-phase AC-AC indirect matrix converters with open-end rectifier stage, IEEE Transactions on Industry Applications (2021).
(7) B. Charaf, L. Hocine, M. Boubekeur, A novel approach for controlling with a matrix converter, Rev. Roum. Sci. Techn. – Électrotechn. Et Énerg., 68, 1, pp. 24–29 (2023).
(8) O. Aydogmus, G. Boztas, R. Celikel, Design, and analysis of a flywheel energy storage system fed by matrix converter as a dynamic voltage restorer, Energy, 238, 121687 (2022).
(9) R. Wang, H. Hao, S. Yuan, X. Hui, High-gain sparse three-level indirect matrix converter and its modulation strategy, Journal of Power Electronics, 22, 4, 569–579 (2022).
(10) S.A. Khanday, O.C. Sekhar, T.N. Mir, Comparative study of three-phase AC/AC in-direct matrix converters: a review, International Conference for Advancement in Technology (ICONAT), IEEE, 1–6 (January 2022).
(11) T. Malakar, V. Siva, S.K. Singh, FPGA-Based Modulation Technique for Five-to-Three-Phase Ultra Sparse Matrix Converter, Recent Trends in Electronics and Communication, Springer, Singapore, 1187–1199 (2022).
(12) K. Nakamura Y. Zhang, T. Onchi, H. Idei, M. Hasegawa K. Tokunaga, K. Hanada, H. Chikaraishi, O. Mitarai, S. Kawasaki, A. Higashijima, Quaternion Analysis of transient phenomena in matrix converter based on space-vector modulation, Plasma and Fusion Research, 17, 2405025–2405025 (2022).
(13) V. Dahiya, G. Leena, Analysis of predictive current control technique in wind energy conversion system, Renewable Energy Optimization, Planning and Control, Springer, Singapore, pp. 101–111 (2022).
(14) M. Selvi, P.M. J. Prathap, Analysis & classification of secure data aggregation in wireless sensor networks, International Journal of Engineering and Advanced Technology. 8, 4, pp. 1404–1407 (2019).
(15) R. Belal, M. Flitti, M.L. Zegai, Tuning of Pi speed controller in direct torque control of dual star induction motor based on genetic algorithms and neuro-fuzzy schemes, Rev. Roum. Sci. Techn. – Électrotechn. Et Énerg., 69, 1, pp. 9–14 (2024).
(16) K. Budo, T. Takeshita, Experimental characteristics of capacitor voltage balancing control in modular matrix converter for isolated medium-voltage AC-DC converter, 23rd European Conference on Power Electronics and Applications (EPE'21 ECCE Europe), pp. 1–10 (2021).
(17) H.F. Ahmed, M.S. El Moursi, B. Zahawi, K. Al Hosani, A.A. Khan, Single-phase symmetric-bipolar-type high-frequency isolated buck-boost AC–AC Converter with continuous input and output currents, IEEE Transactions on Power Electronics, 36, 10, pp.11579–11592 (2021).
(18) N. Taheri H. Orojlo, F. Ebrahimi, Damping controller design in offshore wind power plants to improve power system stability using fractional order PID controllers based on optimized exchange market algorithm, Journal of Intelligent Procedures in Electrical Technology, 13, 51, pp. 91–110 (2022).
(19) Y. Mousavi, G. Bevan, I.B. Kucukdemiral, A. Fekih, Sliding mode control of wind energy conversion systems: Trends and applications, Renewable and Sustainable Energy Reviews, 167, 112734 (2022).
(20) D. Shunmugham Vanaja, A.A. Stonier, A novel PV-fed asymmetric multilevel inverter with reduced THD for a grid‐connected system, International Transactions on Electrical Energy Systems, 30, 4, e12267 (2020).
(21) P.M.J. Prathap, V.G. Menon, Survey on latest energy-based routing protocols for underwater wireless sensor networks, Journal International Journal of Computer Networks and Wireless Communications (IJCNWC), 66 (2016).
(22) D. Shunmugham Vanaja, A.A. Stonier Grid integration of modular multilevel inverter with improved performance parameters, International Transactions on Electrical Energy Systems, 31, 1, p.e. 12667 (2021).
(23) M.A. Ebrahim, M. Becherif, A.Y. Abdelaziz, Dynamic performance enhancement for wind energy conversion system using Moth-Flame Optimization based blade pitch controller, Sustainable Energy Technologies and Assessments, 27, 206–212 (2018).
(24) Q. Wang, H. Xi, F. Deng, M. Cheng, G. Buja, Design and analysis of genetic algorithm and BP neural network based PID control for boost converter applied in renewable power generations, IET Renewable Power Generation, 16, 7, 1336–1344 (2022).
(25) K. Aseem, S.S. Kumar, Hybrid k-means grasshopper optimization algorithm based FOPID controller with feed-forward DC–DC converter for solar-wind generating system, Journal of Ambient Intelligence and Humanized Computing, 13, 5, pp. 2439–2462 (2022).
(26) S. Sharma, V.K. Tayal, Optimised controller design for frequency control of a wind turbine driven doubly fed induction generator. International Journal of Ambient Energy, pp. 1–10 (2022).
(27) F. Amrane, A. Chaiba, B. Francois, B. Babes, Real-time implementation of grid-connection control using robust PLL for WECS in variable speed DFIG-based on HCC,. 5th International Conference on Electrical Engineering-Boumerdes (ICEE-B), 1–5 (2017). IEEE.
(28) F. Amrane, A. Chaiba, B. Francois, B. Babes,. Real time implementation of grid-connection control using robust PLL for WECS in variable speed DFIG-based on HCC, 5th International Conference on Electrical Engineering-Boumerdes (ICEE-B), pp. 1–5 (2017). IEEE.
(29) B. Babes, O. Aissa, N. Hamouda, I. Colak, Model based predictive direct torque and flux control for grid synchronization of a PMSG driven by a direct matrix converter, 10th International Conference on Smart Grid (icSmartGrid), IEEE, pp. 208–213 (2022).
(30) M. Israyelu, S. Sashidhar, Hybrid switched inductor step-up ultra-sparse matrix converter for wind generator applications. In IECON, Annual Conference of the IEEE Industrial Electronics Society, pp. 1–6, (2021). IEEE.
(31) V. Siva, M. Raghuram, A. Singh, S.K. Singh, Y.P. Siwakoti, Switching strategy to reduce inductor current ripple and common mode voltage in quasi Z-source ultra sparse matrix converter, IEEE Journal of Emerging and Selected Topics in Industrial Electronics, 4, 4, pp. 1159-1169 (2023).
(32) A. Appathurai, P. Deepa, Design for reliability: A novel counter matrix code for FPGA based quality applications, 6th Asia Symposium on Quality Electronic Design (ASQED), IEEE, pp. 56–61 (2015).
(33) P.G. Sreelekshmi, S.C. Ramesh, Dingo Optimized Fuzzy CNN technique for efficient protein structure prediction, International Journal of Data Science and Artificial Intelligence, 01(02), 32–40 (2023).
(34) A. Ahilan, P. Deepa, Modified decimal matrix codes in FPGA configuration memory for multiple bit upsets, International Conference on Computer Communication and Informatics (ICCCI), IEEE, pp. 1–5 (2015).
(35) C. Senthil Singh, Sameena Naaz, G. Saranya, IOT-centric data protection using deep learning technique for preserving security and privacy in cloud, International Journal of Data Science and Artificial Intelligence, 2, 3, pp. 81–87 (2024).
Downloads
Published
Issue
Section
License
Copyright (c) 2024 REVUE ROUMAINE DES SCIENCES TECHNIQUES — SÉRIE ÉLECTROTECHNIQUE ET ÉNERGÉTIQUE
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
