IMPROVING THE OUTPUT OF DC-DC CONVERTER BY PHASE SHIFT FULL BRIDGE APPLIED TO RENEWABLE ENERGY

Authors

  • THAO HUYNH VAN University of Science and Technology - The University of Danang Author
  • THANH LE VAN University of Science and Technology - The University of Danang Author
  • TUYET MAI NGUYEN THI University of Science and Technology - The University of Danang Author
  • MINH QUAN DUONG University of Science and Technology - The University of Danang Author
  • GABRIELA NICOLETA SAVA University POLITEHNICA of Bucharest Author

Keywords:

Dc-dc converter, Phase shift full bridge converter (PSFB), Proportional-integral controller (PI)

Abstract

The dc-dc converter is crucial for boosting the output voltage of renewable energy sources, particularly wind energy. In this paper, the dc-dc converters: boost converter, flyback converter, push-pull converter, and phase shift full bridge converter (PSFB) will be compared in terms of output voltage, current and power to determine which one is the best. The phase shift full bridge converter was chosen to improve the dc-dc converter's output. Performance of each converter is simulated using MATLAB/SIMULINK.

References

(1) L. Tuan, M.Q. Duong, G.N. Sava, V. Tanasiev, Optimization of renewable energy sources operation in Vietnam’s electricity market, Rev. Roum. Sci. Techn. – Électrotechn. Et Énerg., 65, 4, pp. 221-217, 2020.

(2) A. Kavousi, S.H. Fathi, J. Milimonfared, M.N. Soltani, Application of Boost converter to increase the speed range of dual-stator winding induction generator in wind power systems, IEEE Trans. on Power Electronics, 33, 11, pp. 9599-9610, 2018.

(3) R. Ramkmar, A.A. Vikram, Wind energy based asymmetrical half bridge flyback converter for BLDC motor, 2017 Third International Conference on Science Technology Engineering & Management (ICONSTEM), pp. 605-610, 2017.

(4) A. Blinov, D. Vinnikov, O. Husev, A. Chub, Experimental Analysis of Wide Input Voltage Range qZS-derived Push-Pull DC/DC Converter for PMSG-based Wind Turbines, Tallinn University of Technology, Estonia, PCIM Europe 2013.

(5) Y. Zhou, D.E. Macpherson, W. Blewitt, D. Jovcic, Comparison of DC-DC converter topologies for offshore wind-farm application, 6th IET International Conference on Power Electronics, Machines and Drives (PEMD 2012), pp. 1-6, 2012.

(6) H. R. Muhammad, Power Electronics Handbook, Academic Press, pp. 211-224, 2001.

(7) B. M. Hasaneen, A.E. Mohammed, Design and simulation of DC/DC boost converter, Power Syst. Conf. 2008. MEPCON. 12th Int. Middle East, pp. 335–340, December 2008.

(8) R. Kanthimathi, J. Kamala, Analysis of different Flyback Converter Topologies, 2015 International Conference on Industrial Instrumentation and Control (ICIC), pp. 1248-1252, 2015.

(9) A. Bogza, D. Floricău, The parallel connection of phase-shifted full-bridge DC-DC converters, Rev. Roum. Sci. Techn. – Électrotechn. Et Énerg., 65, 4, pp. 229-234, 2020.

Downloads

Published

09.12.2021

Issue

Section

Électrotechnique et électroénergétique | Electrical and Power Engineering

How to Cite

IMPROVING THE OUTPUT OF DC-DC CONVERTER BY PHASE SHIFT FULL BRIDGE APPLIED TO RENEWABLE ENERGY. (2021). REVUE ROUMAINE DES SCIENCES TECHNIQUES — SÉRIE ÉLECTROTECHNIQUE ET ÉNERGÉTIQUE, 66(3), 175-180. https://journal.iem.pub.ro/rrst-ee/article/view/32