HESSIAN-FREE FLUX OPTIMIZATION FOR ENERGY-EFFICIENT INDUCTION MOTOR DRIVES: EXPERIMENTAL VALIDATION
DOI:
https://doi.org/10.59277/RRST-EE.2026.4.1Keywords:
Induction motor drives, Hessian-Free Optimization, Field-oriented control, Efficiency optimizationAbstract
Conventional field-oriented control (FOC) of induction motor drives typically employs a fixed flux reference, leading to reduced energy efficiency, particularly under light-load conditions due to excessive excitation and increased losses. To address this limitation, this paper proposes a lightweight Hessian-free adaptive flux optimization strategy. A simple real-time update law for the d-axis current is developed, enabling effective loss minimization without requiring second-order derivative computation, iterative optimization, or additional hardware. By capturing the nonlinear coupling between torque demand and excitation, the method dynamically adjusts the flux while preserving the conventional FOC structure. Experimental results demonstrate significant efficiency improvement over a wide operating range, with efficiency increasing from 31.02% to 61.87% under light-load conditions and from 69.07% to 77.61% at rated load compared to conventional PI-based FOC. The proposed approach provides a low-complexity solution suitable for real-time industrial applications.
References
(1) J. Holtz, “Sensorless control of induction motor drives”, Proc. IEEE, 90, 8, pp. 1359–1394 (2002).
(2) I.M. Mehedi, N. Saad, M.A. Magzoub, U.M. Al Saggaf, A.H. Milyani, “Simulation analysis and experimental evaluation of improved field-oriented controlled induction motors incorporating intelligent controllers”, IEEE Access, 10, pp. 18380–18394 (2022).
(3) M.G. Simões, “A concise history of induction motor drives—Part 1”, IEEE Electrification Magazine, 11, 2, pp. 5–11 (2023).
(4) T. Orłowska Kowalska, M. Korzonek, G. Tarchała, “Stability improvement methods of the adaptive full order observer for sensorless induction motor drive—Comparative study”, IEEE Trans. Ind. Inform., 15, 11, pp. 6114–6126 (2019).
(5) N.T. Pham, “A hybrid intelligent control framework with real-time validation for induction motor drives”, Rev. Roum. Sci. Techn. – Électrotechn. Et Énerg., 71, 1, pp. 45–52 (2026).
(6) A.M. Bazzi, P.T. Krein, "Review of methods for real time loss minimization in induction machines”, IEEE Trans. Ind. Appl., 46, pp. 2319–2328 (2010).
(7) Z. Qu, M. Ranta, M. Hinkkanen, J. Luomi, “Loss-minimizing flux level control of induction motor drives”, IEEE Trans. Ind. Appl., 48, 3, pp. 952–961 (2012).
(8) M. Abdelwanis, R. El Sehiemy, “Efficient parameter estimation procedure using sunflower optimization algorithm for six phase induction motor”, Rev. Roum. Sci. Techn. – Électrotechn. Et Énerg., 67, 3, pp. 259–264 (2022).
(9) R. Sivaraju, R. Dhanabal, P. Kumar, P. Vijayakumar, K. Jayakumar, “Improving the efficiency of induction motor drive by flux and torque control: A hybrid LSE RERNN approach”, ISA Transactions, 147, pp. 215–226 (2024).
(10) L. Wogi, M. Morawiec, T. Ayana, P. Kołodziejek, “Multiscalar control-based flux optimization for efficiency improvement of induction motor”, IEEE Trans. Transp. Electr., 11, 6, pp. 14047–14061 (2025).
(11) A. De Keyser, H. Vansompel, G. Crevecoeur, “Real-time energy-efficient actuation of induction motor drives using approximate dynamic programming”, IEEE Trans. Ind. Electron., 68, 12, pp. 11837–11846 (2021).
(12) R. Basak, A.K. Paul, “Cost-effective design of three-phase induction motor: An optimization approach”, Rev. Roum. Sci. Techn. – Électrotechn. Et Énerg., 67, 4, pp. 461–466 (2022).
(13) M.S. Mousavi, S. Rezaei, A. Khayati, H. Oraee, “Predictive torque control of induction motor based on a robust integral sliding mode observer”, IEEE Trans. Ind. Electron., 70, 3, pp. 2339–2350 (2023).
(14) Y. Zhang, Z. Yin, R. Tang, J. Liu, “Moment of inertia and load torque identification based on adaptive extended Kalman filter for interior permanent magnet synchronous motors”, IEEE Trans. Instrum. Meas., 74, pp. 1–12 (2025).
(15) Y. El.-G. Boudissa, M. Bounekhla, F. Habbi, “Enhanced spiral dynamic algorithm with application to induction motor parameters identification”, Rev. Roum. Sci. Techn. – Électrotechn. Et Énerg., 70, 4, pp. 441–448 (2026).
(16) I. Sami, S. Ullah, A. Basit, N. Ullah, J. Ro, “Integral super twisting sliding mode based sensorless predictive torque control of induction motor”, IEEE Access, 8, pp. 186740–186755 (2020).
(17) J. Martens, “Deep learning via Hessian free optimization”, Proc. Int. Conf. Mach. Learn., pp. 735–742 (2010).
(18) Y. Zhang, Y. Bai, H. Yang, B. Zhang, “Low switching frequency model predictive control of three level inverter fed IM drives with speed sensorless and field weakening operations”, IEEE Trans. Ind. Electron., 66, 6, pp. 4262–4272 (2019).
(19) Y. Zhang, L. Shao, Z. Yin, C. Bai, J. Liu, “Ultralocal model-based model predictive torque control of induction motor drives with model free speed controller”, IEEE Trans. Ind. Electron., 72, 9, pp. 8962–8973 (2025).
(20) N.I. Nahin, M.S. Kaiser, M.T. Arif, S. Shama, R. Ahmed, “Predictive torque control with reduced voltage vectors for voltage source inverter-driven induction motor drives”, IEEE Trans. Appl. Supercond., 34, 8, pp. 1–5 (2024).
(21) W. Xu, Y. Tang, D. Dong, X. Xiao, E.E.M. Rashad, A.K. Junejo, “Optimal reference primary flux-based model predictive control of linear induction machine with MTPA and field weakening operations for urban transit”, IEEE Trans. Ind. Appl., 58, 4, pp. 4708–4721 (2022).
(22) Y. Gong, X. Zhao, L. Wang, “Improved robust model predictive current control via high-order terminal sliding mode control for permanent magnet synchronous motor”, IEEE Trans. Autom. Sci. Eng., 23, pp. 5237–5249 (2026).
(23) I.D. De Martin, F. Tinazzi, M. Zigliotto, “Tuning less model predictive torque control for synchronous motor drives with maximum torque per ampere criterion including transients”, IEEE Trans. Power Electron., 40, 9, pp. 12393–12401 (2025).
(24) S. Zhang, R. Chen, W. Du, Y. Yuan, V.S. Vassiliadis, “Neural speed torque estimator for induction motors in the presence of measurement noise”, IEEE Trans. Ind. Electron., 70, 1, pp. 167–177 (2023).
(25) X. Guo, Q. Yang, Q. Wang, Y. Sun, A. Tan, “Electromagnetic torque modeling and validation for a permanent magnet spherical motor based on XGBoost”, Simulation Modeling Practice and Theory, 136, article 102989 (2024).
(26) N. Ali, W. Alam, M. Pervaiz, J. Iqbal, “Nonlinear adaptive backstepping control of permanent magnet synchronous motor," Rev. Roum. Sci. Techn. – Électrotechn. Et Énerg., 66, 1, pp. 9–14 (2021).
(27) S. Zhang, R. Chen, W. Du, Y. Yuan, V.S. Vassiliadis, “A Hessian-free gradient flow method for the optimization of deep learning neural networks”, Comput. Chem. Eng., 141, article 107008 (2020).
(28) Z.-D. Zhou, G. Guo, R. Zhang, “Hessian free fixed /predefined time algorithms for distributed time-varying optimization”, IEEE Trans. Syst., Man, Cybern.: Syst., 55, 10, pp. 6890–6900 (2025).
(29) Y. He, P. Gong, Z. Lu, “Efficiency optimization strategy of induction motor based on electromagnetic and reactive torque control”, IEEE Trans. Transp. Electrific., 11, 6, pp. 13815–13825 (2025).
Downloads
Published
Issue
Section
License
Copyright (c) 2026 REVUE ROUMAINE DES SCIENCES TECHNIQUES — SÉRIE ÉLECTROTECHNIQUE ET ÉNERGÉTIQUE

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.