PROCESSOR-IN-THE-LOOP VALIDATION OF SENSORLESS DIRECT TORQUE CONTROL FOR PARALLEL FIVE-PHASE PMSM DRIVES
DOI:
https://doi.org/10.59277/RRST-EE.2026.4.6Keywords:
Five-phase permanent magnet synchronous machine (PMSM), Parallel-connected drives, Direct torque control with space vector modulation (DTC-SVM), Model reference adaptive system (MRAS), Sensorless control, Processor-in-the-loop.Abstract
This paper presents a sensorless model reference adaptive system (MRAS) speed and position estimator embedded in a direct torque control with space vector modulation (DTC-SVM) scheme for two five-phase permanent magnet synchronous machines (PMSMs) connected in parallel to a single five-phase inverter. The MRAS jointly estimates rotor speed, position, torque, and stator flux for each machine, removing the need for mechanical sensors while keeping the two drives fully decoupled despite sharing one inverter. The scheme is validated experimentally through processor-in-the-loop (PIL) co-simulation, running the control algorithm on an STM32F407 Discovery board coupled to a MATLAB/Simulink SimPowerSystems plant model over a UART link. Across four test scenarios — co-directional speed tracking, counter-rotating operation, alternating high-speed reversal, and low-speed operation — the estimator tracks the reference speeds closely (peak transient error below 0.1 rad/s, settling below 0.02 rad/s at low speed), the stator flux remains constant near 0.3 Wb, and the two machines remain fully decoupled: load, speed, or direction changes on one drive produce no measurable disturbance on the other.
References
(1) E. Levi, “Multiphase electric machines for variable-speed applications,” IEEE Trans. Ind. Electron., 55, 5, pp. 1893–1909 (2008).
(2) L. Parsa, H.A. Toliyat, “Five-phase permanent-magnet motor drives,” IEEE Trans. Ind. Appl., 41, 1, pp. 30–37 (2005).
(3) M. Jones, S.N. Vukosavic, E. Levi, “Parallel-connected multiphase multidrive systems with single inverter supply,” IEEE Trans. Ind. Electron., 56, 6, pp. 2047–2057 (2009).
(4) Q. Geng, Z. Zhou, G. Zhang, C. Xia, “Sensorless control method for dual permanent magnet synchronous motors driven by five-leg voltage source inverter,” IEEE J. Emerg. Sel. Top. Power Electron., 9, 5, pp. 5828–5837 (2021).
(5) K.M.S. Benzaoui, E. Benyoussef, A.Z. Kouache, “Three-level direct torque control based on common mode voltage reduction strategy fed two parallel-connected five-phase induction machine,” Rev. Roum. Sci. Techn. – Électrotechn. et Énerg., 69, 2, pp. 177–182 (2024).
(6) T.G. Habetler, F. Profumo, M. Pastorelli, L.M. Tolbert, “Direct torque control of induction machines using space vector modulation,” IEEE Trans. Ind. Appl., 28, 5, pp. 1045–1053 (1992).
(7) F. Mehedi, I. Bouyakoub, A. Belhamel, “Multi-phase permanent magnet synchronous motor using direct torque adaptive fuzzy control,” Rev. Roum. Sci. Techn. – Électrotechn. et Énerg., 70, 4, pp. 470–476 (2025).
(8) B. Mokhtari, M.A. Moussa, “Neural switching tables for a four-level multicellular inverter to enhance direct torque control of a PMSM,” Rev. Roum. Sci. Techn. – Électrotechn. et Énerg., 71, 1, pp. 27–32 (2026).
(9) I. Assoun, L. Idkhajine, B. Nahid-Mobarakeh, “Wide-speed range sensorless control of five-phase PMSM drive under healthy and open phase fault conditions for aerospace applications,” Energies, 16, 1, art. 279 (2023).
(10) Z. Ider, Y. Bourek, D. Taibi, “Sensorless optimal control of a five-phase induction motor with harmonic minimization,” Rev. Roum. Sci. Techn. – Électrotechn. et Énerg., 71, 1, pp. 9–14 (2026).
(11) C. Hadji, D.E. Khodja, “A sensorless adaptive backstepping sliding mode control of double star induction motor,” Rev. Roum. Sci. Techn. – Électrotechn. et Énerg., 71, 3, pp. 343–348 (2026).
(12) C. Schauder, “Adaptive speed identification for vector control of induction motors without rotational transducers,” IEEE Trans. Ind. Appl., 28, 5, pp. 1054–1061 (1992).
(13) Z. Jiang, R. Leonard, R. Dougal, H. Figueroa, A. Monti, “Processor-in-the-loop simulation, real-time hardware-in-the-loop testing and hardware validation of a digitally-controlled, fuel-cell powered battery-charging station,” 2004 IEEE 35th Annual Power Electronics Specialists Conference (PESC), Aachen, Germany, 20–25 June (2004).
(14) L. Belhamel, A. Buscarino, A. Cucuccio, L. Fortuna, G. Rasconà, “Model-based design streamlines for STM32 motor control embedded software system,” 2020 7th International Conference on Control, Decision and Information Technologies (CoDIT), Prague, Czech Republic, June (2020).
(15) M. Hu, H. Ahn, J. Park, K. You, “Novel rapid control prototyping for permanent magnet synchronous motor via model-based design and STM32 chip,” Int. J. Adv. Manuf. Technol., 135, art. 104274 (2024).
(16) T. Kamel, D. Abdelkader, B. Said, S. Padmanaban, A. Iqbal, “Extended Kalman filter-based sliding mode control of parallel-connected two five-phase PMSM drive system,” Electronics, 7, 2, art. 14 (2018).
(17) H. Kubota, K. Matsuse, “Speed sensorless field-oriented control of induction motor with rotor resistance adaptation,” IEEE Trans. Ind. Appl., 30, 5, pp. 1219–1224 (1994).
(18) M. Errouha, Q. Combe, S. Motahhir, S.S. Askar, M. Abouhawwash, “Design and processor-in-the-loop implementation of an improved control for IM-driven solar PV-fed water pumping system,” Sci. Rep., 12, art. 4688 (2022).
Downloads
Published
Issue
Section
License
Copyright (c) 2026 REVUE ROUMAINE DES SCIENCES TECHNIQUES — SÉRIE ÉLECTROTECHNIQUE ET ÉNERGÉTIQUE

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.