ANALYSIS OF A NON-ISOLATED FORM OF DC-DC CONVERTER WITH ENHANCED QUADRATIC VOLTAGE GAIN

Authors

  • MURALI DURAISAMY Department of EEE, Government College of Engineering Srirangam, Tiruchirappalli, India. Author
  • VIDHARSHAN MURALI Department of EEE, Sona College of Technology, Salem, India. Author

DOI:

https://doi.org/10.59277/RRST-EE.2026.4.9

Keywords:

Continuous inductor current mode, DC-DC power electronic converter, Duty ratio, Prototype converter setup, Quadratic-based voltage gain, Reduced switch voltage stress, Steady-state behavior

Abstract

Among the various renewable energy resources, the solar photovoltaic (PV) method of electrical energy generation offers advantages such as reduced environmental pollution compared to the conventional fossil fuel method, its availability, and the limitless availability of solar energy. The solar PV panels produce power only at a low DC output voltage. The solar PV array connected to a low-voltage DC bus cannot supply power directly to the high-voltage DC loads. An intermediate high-gain DC-DC power electronic converter is required for enhancing the solar PV panel’s output voltage. Traditional non-isolated DC-DC boost converter structures can achieve higher DC output voltages only at high duty ratios. A non-isolated continuous inductor current-mode-based DC-DC converter that can produce quadratic-based enhanced voltage gain at low duty cycle is proposed in this paper. The suggested topology has fewer semiconductor-based and passive components and reduces active power-switch voltage stress. The steady state behavior of the converter is explored. A prototype converter model is constructed and tested in a laboratory environment to validate its results at a duty ratio of 0.6.

References

(1) H.A. Mosallam, “A systematic review of DC-DC converter technologies: traditional, bidirectional, and impedance-source topologies,” Discover Electronics, 3, 16, pp. 1–65 (2026).

(2) X. Wu, J. Wang, Y. Zhang, J. Du, Z. Liu, Y. Chen, “Review of DC-DC converter topologies based on impedance network with wide input voltage range and high gain for fuel cell vehicles,” Automotive Innovation, 4, pp. 351–372 (2021).

(3) P. Anbarasu, N.K. Loganathan, A. Narendran, K. Rameshkumar, “Metaheuristic-driven dual inductor boost converter for floating PV systems in MATLAB/Simulink,” Rev. Roum. Sci. Techn. – Électrotechn. et Énerg., 71, 1, pp. 103–108 (2026).

(4) N.B. Dişken, M.M. Savrun, “High-gain multi-port DC-DC converter topologies for renewable energy applications: a comprehensive review,” Electric Power Components and Systems, 52, 8, pp. 1459–1473 (2024).

(5) S.A. Gorji, A. Mostaan, H.T. My, M. Ektesabi, “Non-isolated buck-boost DC-DC converter with quadratic voltage gain ratio,” IET Power Electronics, 12, 6, pp. 1425–1433 (2019).

(6) T. Nivetha, V. Lavanya, P. Sriramalakshmi, “Review of DC-DC boost converter derived topologies for renewable energy applications,” International Journal of Power Electronics and Drive Systems, 15, 2, pp. 947–957 (2024).

(7) D. Murali, “Analysis and experimental validation of a non-isolated DC-DC SEPIC-modified CUK combined converter,” Rev. Roum. Sci. Techn. – Électrotechn. et Énerg., 70, 3, pp. 367–372 (2025).

(8) S. Coelho, V. Monteiro, J.L. Afonso, “Topological advances in isolated DC-DC converters: high-efficiency design for renewable energy integration,” Sustainability, 17, pp. 1–40 (2025).

(9) Y. Supriya, J.S. Rajashekar, “A comprehensive review of various isolated DC-DC converter topologies associated with photovoltaic applications,” Recent Advances in Electrical and Electronic Engineering, 15, 8, pp. 595–606 (2022).

(10) P.K. Maroti, S. Padmanaban, J.B.H. Nielsen, M.S. Bhaskar, M. Meraj, A. Iqbal, “A new structure of high-voltage-gain SEPIC converter for renewable energy applications,” IEEE Access, 7, pp. 89857–89868 (2019).

(11) G. Guerin, G.A. Rincon-Mora, “Switched-inductor DC-DC converters: direct small-signal equivalent AC circuit,” Electronics, 15, 5, pp. 1–18 (2026).

(12) P. Biswal, V.V.S.K. Bhajana, A. Iqbal, V. Kakani, M. Popuri, “Extended high gain DC-DC converter with switched-inductors, switched-capacitors and soft-switching: analysis and implementation,” IET Power Electronics, 17, 11, pp. 1445–1456 (2024).

(13) M. Kalarathi, J. Gnanavadivel, K. Jayanthi, “High-boost DC-DC converter based on switched inductor, switched capacitor and voltage multiplier cell,” Iranian Journal of Science and Technology, Transactions of Electrical Engineering, 48, pp. 965–978 (2024).

(14) M.E. Azizkandi, F. Sedaghati, H. Shayeghi, F. Blaabjerg, “A high-voltage DC-DC converter based on a three-winding coupled inductor and voltage multiplier cell,” IEEE Transactions on Power Electronics, 35, 5, pp. 4558–4567 (2020).

(15) A. Alzahrani, M. Ferdowsi, P. Shamsi, “A family of scalable non-isolated interleaved DC-DC boost converters with voltage multiplier cells,” IEEE Access, 7, pp. 11707–11721 (2019).

(16) D. Murali, “A transformerless boost-modified CUK combined single-switch DC-DC converter topology with enhanced voltage gain,” Brazilian Archives of Biology and Technology, 66, 3, pp. 1–20 (2023).

(17) M. Karthikeyan, R. Elavarasu, P. Ramesh, C. Bharatiraja, P. Sanjeevikumar, L. Mihet-Popa, M. Mitolo, “A hybridization of CUK and boost converter using single switch with higher voltage gain capability,” Energies, 13, 9, pp. 1–24 (2020).

(18) D. Murali, “Closed-loop implementation of a non-isolated high step-up integrated SEPIC-CUK DC-DC converter structure with single switch,” Brazilian Archives of Biology and Technology, 67, 2, pp. 1–15 (2024).

(19) K.A. Mahafzah, M.A. Obeidat, A. Mansour, E.R. Sanseverino, G. Zizzo, “A new smart grid hybrid DC-DC converter with improved voltage gain and synchronized multiple outputs,” Applied Sciences, 14, 6, pp. 1–18 (2024).

(20) S. Ranganathan, A.N.D. Mohan, “Formulation and analysis of single-switch high-gain hybrid DC-to-DC converter for high-power applications,” Electronics, 10, 19, pp. 1–14 (2021).

(21) L. Díaz-Saldierna, J. Morales-Saldaña, M. Ortiz-López, “Switching regulator using a quadratic boost converter for wide DC conversion ratios,” IET Power Electronics, 2, 5, pp. 605–613 (2009).

(22) N. Subhani, Z. May, M.K. Alam, S. Mamun, “An enhanced gain non-isolated quadratic boost DC-DC converter with continuous source current,” PLoS ONE, 18, 12, pp. 1–25 (2023).

(23) J. Gnanavadivel, M. Kalarathi, K. Prakash, “A double-switch integrated high-gain quadratic boost converter for electric vehicle applications,” Rev. Roum. Sci. Techn. – Électrotechn. et Énerg., 70, 4, pp. 495–500 (2025).

(24) A.B. Reddy, S.N. Mahato, N. Tewari, “Dual-switch ultra-high-gain DC-DC converter with low-voltage stress,” International Journal of Electronics and Communication (AEU), 173, pp. 1–11 (2024).

(25) S. Bhavani, A. Sivaprakasam, “Sliding mode controlled closed-loop quadratic boost converter three-phase inverter system-fed permanent synchronous motor drive with enhanced response,” Rev. Roum. Sci. Techn. – Électrotechn. et Énerg., 70, 3, pp. 331–336 (2025).

(26) R. Rostami, S.H. Hosseini, M.B.B. Sharifian, “High-gain non-isolated step-up DC-DC converter proper for renewable energy applications,” Scientific Reports, 15, 1, pp. 1–24 (2025).

(27) S. Radhakrishnan, M. Veerasamy, “Modified multi-stage quadratic DC-DC converter with voltage multiplier for solar PV applications,” International Journal of Electronics, 113, 6, pp. 1145-1168 (2026).

(28) N. Dizangian, S. Jovanović, P. Poure, “Modeling and experimental verification of a single-switch quadratic boost DC-DC converter with high voltage gain for energy harvesting,” Energies, 18, 20, pp. 1–31 (2025).

(29) B. Babaiahgari, J.E. Valdez-Resendiz, A.A. Reyes, J.C. Rosas-Caro, E.D. Silva-Vera, “Quadratic boost converter with reduced input current ripple,” Applied Sciences, 15, 19, pp. 1–20 (2025).

(30) K. Jayanthi, S. Narthana, J. Gnanavadivel, “A single-switch non-isolated quadratic high-gain configuration for renewable energy applications,” Rev. Roum. Sci. Techn. – Électrotechn. et Énerg., 71, 1, pp. 97–102 (2026).

(31) J.L. Ramos, R.M. Varona, M.G.O. Lopez, L.H. Díaz-Saldierna, D.L. Cordoba, “Control strategy of a quadratic boost converter with voltage multiplier cell for high-voltage gain,” IEEE Journal of Emerging and Selected Topics in Power Electronics, 5, 4, pp. 1761–1770 (2017).

(32) J. Ahmad, M. Zaid, A. Sarwar, C.H. Lin, M. Asim, R.K. Yadav, M. Tariq, K. Satpathi, B. Alamri, “A new high-gain DC-DC converter with continuous input current for microgrid applications,” Energies, 14, 9, pp. 1–14 (2021).

Downloads

Published

20.11.2026

Issue

Section

Électronique et transmission de l’information | Electronics & Information Technology

How to Cite

DURAISAMY, M., & MURALI, V. (2026). ANALYSIS OF A NON-ISOLATED FORM OF DC-DC CONVERTER WITH ENHANCED QUADRATIC VOLTAGE GAIN. REVUE ROUMAINE DES SCIENCES TECHNIQUES — SÉRIE ÉLECTROTECHNIQUE ET ÉNERGÉTIQUE, 71(4), 531-536. https://doi.org/10.59277/RRST-EE.2026.4.9